Notifications
Clear all
Today I replaced a defective baking element (WPW10207397) in a Whirlpool (GBS277PDQ7) electric wall oven. But once I turn on the circuit breaker, the element start to glow by itself without engaging oven controls. I suspect relays might have gone bad. Long hold on "CANCEL" button yields code "E0-F0-". I think that is "no failure". Is this something you can fix? I am also attaching picture since the board has many numbers and other online references such as 4452892 and WPL 8186024.
Thank You
Topic starter
Posted : 11/29/2022 3:48 pm
Thank you for reaching out. It sounds like the board is working properly. Doing a reset could help. I have provided a link that can get you started and a guide to go through to narrow down where the issue is. If you have checked everything that is recommended then I would consider sending the board in for repair.
https://www.upfix.com/product/4452898-whirlpool-range-stove-oven-control-board-repair/
https://forum.upfix.com/range-stove-oven/oven-stove-not-working/
Posted : 11/29/2022 3:48 pm