Bosch Fault Codes for Range/Stove/Oven
| Failure Code |
Fault Code Description |
Solution |
| F32 |
Lower oven temperature sensor failure; an open or short circuit in the lower oven sensor wiring |
- Check all connections, especially P24 on the power board.
- Unplug the senor connector and check sensor resistance (approximately 1080 ohms at room temperature with connector remove). Remember to reconnect it.
- Check that neither sensor wire is open or pinched to the appliance chassis.
- Check that the solder joint in header P24 on the power board are not broken.
- If sensor is OK, replace/repair control board. UpFix.com can rebuild your faulty control board.
|
| F41 |
Upper (or single) oven motorized latch will not lock; defective or jammed upper (or single) oven door or latch switches; defective latch motor or its wiring. |
- Check P24 connector on the power board.
- Ensure door latch switches are operating properly.
- Check that neither latch switch nor common wires are pinched to the appliance chassis.
- Check that the solder joints in header P24 on the power board are not broken.
- Check P10 connector and check if latch motor wire is pinched to the appliance chassis.
|
| F42 |
Lower motorized latch will not lock; defective or jammed lower oven door or latch switches; defective latch motor or its wiring. |
- Check P24 connector on the power board.
- Ensure door latch switches are operating properly.
- Check that neither latch switch nor common wires are pinched to the appliance chassis.
- Check P10 connector and check if latch motor wire is pinched to the appliance chassis.
- If F42 persists, replace/repair control board. UpFix.com can rebuild your faulty control board.
|
| F43 |
Upper (or single) oven motorized latch will not lock; defective or jammed upper (or single) oven door or latch switches; defective latch motor or its wiring. |
- Check P24 connector on the power board.
- Ensure door latch switches are operating properly.
- Check that neither latch switch nor common wires are pinched to the appliance chassis.
- Check P10 connector and check if latch motor wire is pinched to the appliance chassis.
- If F43 persists, replace/repair control board. UpFix.com can rebuild your faulty control board.
|
| F44 |
Lower motorized latch will not lock; defective or jammed lower oven door or latch switches; defective latch motor or its wiring. |
- Check P24 connector on the power board.
- Ensure door latch switches are operating properly.
- Check that neither latch switch nor common wires are pinched to the appliance chassis.
- Check P10 connector and check if latch motor wire is pinched to the appliance chassis.
|
| F45 |
Upper (or single) oven motorized latch will not lock; defective or jammed upper (or single) oven door or latch switches; defective latch motor or its wiring. |
- Check P24 connector on the power board.
- Ensure door latch switches are operating properly.
- Check that neither latch switch nor common wires are pinched to the appliance chassis.
- If F45 persists, replace/repair control board. UpFix.com can rebuild your faulty control board.
|
Faulty Control Board Module?
Get yours repaired and save hundreds of dollars!
We can rebuild your faulty control board module, here is the repair link https://www.upfix.com/product-category/appliances/range-stove-oven/
Quote
Topic starter
Posted : 10/02/2021 9:40 pm
