Notifications
Clear all
There are no errors displayed. Can only run on rapid load, does not run entire cycle, stops when to spin rinse, must shut machine down, manually set at end for rinse spin TO FINISH.
Topic starter
Posted : 12/07/2021 5:05 pm
This problem appears to be caused by a malfunctioning control board, based on the description. Check to see if there are any obstructions in the drain that might be preventing the unit from completing the cycle. You may also visit the tech sheet on the equipment and perform a diagnostic to see if any fault codes have been saved. After checking everything and all looks good. But you still have the same problem, then the control board is most likely faulty. We can repair faulty control boards. Here is a link https://www.upfix.com/product-category/appliances/washing-machine/
Posted : 12/07/2021 7:33 pm