Notifications
Clear all
The Frigidaire dryer would start the cycle, then beep and flash the lights for a few minutes before shutting down. The thermostats, heating coil, fuse, and motor switch were all checked. Everything appears to be in order. Except that when I tested the red and black heater wires on the back of the main control board, I discovered that the red had 120 volts and the black has no output. So, with the dryer turned on, I tested the relay for continuity and found none. Do you have any suggestions?
Topic starter
Posted : 11/12/2021 1:41 pm
The relay on the circuit board is broken. It'd have to be repaired. Here is the service link https://www.upfix.com/product-category/appliances/dryer/
Posted : 11/12/2021 4:09 pm