Notifications
Clear all
Dryer is not heating.
Thermistor test 10k ohms at room temp, ok,
high limit ok, continuity at room temp, tested at temp cuts out at 231 degrees, rated at 230
old ignitor no continuity, new ignitor continuity good.
thermal fuse continuity good
Over temp sensor continuity at room temp, ok.
Moisture sensor bars working.
Does not send signal to charge ignitor and open gas valve.
Is there something I can test on this board to verify it is defective before I decide to chance $90 repair? I don't want to put any other money into what may be a different problem than the board.
Topic starter
Posted : 11/15/2021 5:48 pm
Thank you for reaching out. One way to test to see, if the control board module is bad you would want to check for voltage going into the control board module and for voltage out. If there is voltage to the control board module, but there is no voltage coming out of the control board module then the module is faulty and would need to be replaced or repaired.
However, sometimes the control board will power up, but certain components on the board could be bad and it will not work correctly on some of the features of the device.
We can rebuild faulty control board modules, here is the link
Posted : 11/15/2021 8:16 pm